You are here:
Home » Routes
There are many ways to advertise BGP routes in Juniper. Today we will learn a few of those. This is the 3rd article on Juniper BGP series. You can check other articles of this series from below list. This list will be updated day by day. For today's article, below…
continue reading →
In this lesson, we will configure iBGP on Cisco Router. This is the second part of our BGP series. We have chosen a network where we have three routers which are not directly connected. We will configure ibgp among them and check the reachability from end to end. Below are…
continue reading →
BGP is an exterior gateway protocol that manages how packets are routed across the internet. It can quickly adapt to send out packets if a path goes down. Because of the variety of ways to do the traffic engineering, this is one of the most popular routing protocols. A series…
continue reading →
Earlier, we have learned, how to configure OSPF on CISCO routers. Today, in this lesson, we will learn how to configure OSPF on Juniper. This process is same for MX, ACX, SRX, EX, and other Junos enabled devices. We will be using following topology for our LAB. So, let's config…
continue reading →
OSPF (Open shortest path first) is an open standard routing protocol, meaning any vendor like Cisco, Juniper, Brocade can implement its features. Today we will discuss how to configure OSPF in Cisco routers. To do so, first we need to enable OSPF in our router. To enable OSPF, we have…
continue reading →