Today, we will learn to configure eBGP on Juniper Router. We will be using a simple point-to-point topology to keep the tutorial simple and to the point. So, let’s get started. Every BGP configuration is done by following 2 steps. […]
In this lesson, we will configure iBGP on Cisco Router. This is the second part of our BGP series. We have chosen a network where we have three routers which are not directly connected. We will configure ibgp among them
BGP is an exterior gateway protocol that manages how packets are routed across the internet. It can quickly adapt to send out packets if a path goes down. Because of the variety of ways to do the traffic engineering, this
In this lesson, we will learn how to configure multi-area OSPF on Juniper. This is the second part of our Juniper OSPF configuration series. Before starting the configuration, we should know a few terms related to the OSPF. These are
Earlier, we have learned, how to configure OSPF on CISCO routers. Today, in this lesson, we will learn how to configure OSPF on Juniper. This process is same for MX, ACX, SRX, EX, and other Junos enabled devices. We will
When we have VLANs in our network, two separate VLANs can’t communicate between them, unless we do the routing between them. Which means, we need a router (L3 device) to make communication between them. In this lesson, we will configure
