You are here:
Home » Let's Config » Page 2
When we have VLANs in our network, two separate VLANs can't communicate between them, unless we do the routing between them. Which means, we need a router (L3 device) to make communication between them. In this lesson, we will configure router for inter VLAN routing. To do that, we will…
continue reading →
In this lesson, we will learn how to configure VRRP on Juniper devices. We will use Juniper SRX box for the lab, however the process for all Junos devices are same. So, let's start. We will configure - Configuration: Before going deeper, let's check our current configuration. Interface: [edit] root@R1#…
continue reading →
In this lesson, we will learn how to configure Palo Alto Networks Firewall Management. Hope, you already know, we have two methods to configure Palo Alto firewall, GUI and CLI. We will use GUI to do Palo Alto Networks Firewall Management Configuration. Here we will configure- By default, Palo Alto…
continue reading →
HSRP (Hot Standby Router Protocol) is one of the most popular First Hop Redundancy Protocols (FHRP) made by Cisco. It is Cisco proprietary protocol. The FHRP allows a router on a LAN segment to automatically take over if other fails. Today, in this lesson, we will learn to configure HSRP…
continue reading →
In this lesson, we will learn how to Configure Juniper SRX as a beginner. We will configure it as our network gateway. We will perform the following activities and it will be updated day by day. So, let's begin with below network topology. If we login to the new SRX…
continue reading →
