How to enable IPv6 on Router
How to enable IPv6 on Router (Cisco IOS) is one of the very basic questions an engineer have, because by default Cisco doesn’t support IPv6 on it’s IOS images. In this tutorial, we will learn how to configure IPv6 in […]
How to configure Telnet on Cisco IOS devices
Hello everyone! Today’s topic is, how to configure Telnet on your Cisco IOS devices. If you are not familiar with Telnet, read this WIKI page. By the end of this article, you will be confident enough to configure and troubleshoot
How to configure SNMP v2c in Cisco IOS Devices
Simple Network Management Protocol (SNMP) is an application layer protocol to collect and organize information about device in an IP network. In this lesson, we will learn to configure SNMP v2c in Cisco device. Pre-Check: Make sure port 161 is
Managing MAC address table in Cisco
Managing MAC address table in Cisco is the most basic but important skill. In this lesson we will discuss in details about it. A Switch manage and use a mac address table to forward traffic from one interface to another.
How to configure SSH on Cisco IOS devices
In this lesson, we will learn how to configure SSH on Cisco IOS enabled devices. This tutorial will show you how to enable SSH, generating RSA key, and then allowing on SSH remote management protocol under the VTY interfaces. This
How to configure OSPF in Cisco Router
OSPF (Open shortest path first) is one of the most popular routing protocol used in enterprise networks and ISPs, because, it’s very efficient and scalable. It’s also an open standard routing protocol, meaning, any OEM (like Cisco, Juniper, Brocade, etc.)